The Daniel Defense M4A1 rifle features the M4A1 RIS II, the same rail system used by the pros at USSOCOM for the SOPMOD II Weapon System. The Daniel Defense M4A1 is built on a carbine length direct impingement operating system with a low profile gas block. The barrel on the M4A1 is 14.5" long, the standard barrel length for an M4 rifle - but has a pinned and welded 1.5" flash hider for an overall barrel length of 16" allowing it to comply with NFA regulations. The pistol grip of DDM4V11 rifle is a proprietary Daniel Defense design with soft touch over molding and the 6-position buttstock features the same soft touch over molding at contact areas.
-
MATERIALS & CONSTRUCTION
- LOWER RECEIVER: Mil-Spec with Enhanced Flared Magazine Well and Rear Receiver QD Swivel Attachment Point. CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized
- UPPER RECEIVER: Mil-Spec with Indexing Marks and M4 Feed Ramps. CNC Machined of 7075-T6 Aluminum, Type III Hard Coat Anodized
- BARREL: Chrome Moly Vanadium Steel, Cold Hammer Forged, 1:7 Twist, 14.5" M4 Profile, Chrome Lined, Mil-Spec Heavy Phosphate Coated, and HP/MPI Tested
- GAS SYSTEM: Pinned Low Profile Gas Block CNC Machined of 4140 Hardened Steel with Mil-Spec Heavy Phosphate Coating, Carbine Length, Direct Impingement
- MUZZLE DEVICE: Pinned and Welded Daniel Defense Flash Suppressor, Extended, 17-4 PH Stainless Steel, Salt Bath Nitride Finished
- BOLT CARRIER GROUP: M16 Profile, Mil-Spec MP Tested, Chrome Lined, Properly Staked Gas Key
- BUFFER: H Buffer
- SIGHTS: Sold Separately
- HANDGUARD: Daniel Defense M4A1 Rail Interface System (RIS) II, CNC Machined of 6061-T6 Aluminum
- CHARGING HANDLE: GRIP-N-RIP Charging Handle, Body CNC Machined of 7075-T6 Aluminum, Handles & Latch CNC Machined of 6061-T6 Aluminum, Heavy Duty Stainless Steel Roll Pins, Type III Hard Coat Anodized
- RECEIVER EXTENSION: 6 Position Mil-Spec 7075-T6 Aluminum
- BUTTSTOCK: Daniel Defense Buttstock, Glass Filled Polymer with Soft Touch Overmolding
- PISTOL GRIP: Daniel Defense Pistol Grip, Glass Filled Polymer with Soft Touch Overmolding
- RAIL PANELS: Daniel Defense Rail Panels made from Santoprene, heat resistant to 300° F.
- Made in the USA
-
Specifications
Mounting System
|
Picatinny
|
Caliber
|
5.56mm NATO
|
Muzzle Thread
|
1 ⁄ 2 × 28 TPI (Threads Per Inch)
|
Gas System
|
Carbine
|
Barrel Length
|
14.5"
|
Barrel Profile
|
M4
|
Product Weight
|
6.74 lbs
|
Length
|
31 1/2” – 34 ¾” (w/ muzzle device)
|
Magazine
|
DD Magazine
|
Case
|
Daniel Defense Full-Latch Impact Plastic Case
|
Determined at checkout.